Reasons Your Water Heater Isn't Working

Go Services

 

 

We've come across this article relating to How to Troubleshoot and Repair an Electric Water Heater listed below on the web and concluded it made perfect sense to share it with you in this article.


No Hot Water — Water Heater Repair
Several modern houses utilize an electrical hot water heater for their heating system, because of its comfort and also ease of use. However, much like any other electric devices, problems may occur with its use, all of a sudden. It can be really frustrating to get up to a chilly shower as opposed to a hot one or having your bath with water that isn't hot sufficient and even also warm. Whatever the case may be, water heater issues can be fairly aggravating. Fortunately, we've made a list of possible options to your hot water heater concerns. There are a variety of variables that could cause a lot of these problems, it could be a problem with the power supply, the electrical heating element, or the thermostat. Prior to doing anything, guarantee you shut off the major power supply for safety. Whatever the problem is, getting it fixed should not pose too much of an issue if you adhere to these actions:

 

Examine Your Power Supply:


As fundamental as this might appear, it is extremely needed. Without appropriate power, your hot water heater will certainly not work. So the first thing to do when your water unexpectedly retires is to verify that it isn't a power issue. Inspect if the fuse is blown out or the circuit breaker tripped. If the breaker is the concern, merely transform it on and off once again. Change any kind of damaged or worn-out fuse. Evaluate the appliance with power after these changes to see if it's currently functioning.

 

Inspect the Heating Element in the Water Heater:


If it's not a power problem, after that attempt taking a look at your heating element if it is still working. Examine each of your burner to make sure the issue isn't with any of them. If any one of them is damaged, change that part and afterwards examine whether the hot water is back on.

 

Check Your Thermostat:


If your water heater still isn't functioning or the water appearing isn't hot enough, you might require to check the temperature setups on your top thermostat. Ensure the circuit breaker is switched off prior to doing anything. Open up the gain access to panel and press the red switch for temperature level reset above the thermostat. This should aid heat up the water. Turn the breaker back on as well as check if the trouble has actually been dealt with.

 

Call A Professional:


If after changing all defective parts and also resetting your temperature, the hot water heater still isn't functioning, you may require to call a specialist plumber for an expert opinion. The trouble with your heater could be that the cold and hot taps have actually been switched or it might be undersized for the amount of warm water required in your home. Whatever the instance may be, a specialist plumber would aid resolve the trouble.

 

Final thought


Hot water heater issues are not always significant. Many of them result from minor concerns like a blown fuse or worn-out heating element. Changing the malfunctioning components ought to suffice. Nevertheless, if you are still incapable to resolve the trouble, give a call to your closest plumber to find to get it fixed.

 

8 possible reasons why you have no Hot Water

 

Along with streaming Netflix and having light flood a room when we flick a switch, having hot water flow from our taps and showerheads whenever we want is an oft-overlooked modern miracle of homeownership. That's why, when that flow goes cold, it can be shocking — and not just in a "Wow, that's freezing" kind of way while you're in the shower.

 

Water Leak

 

Before hot water reaches your taps and showerheads, it needs to spend some time in your water heater. This appliance, which can be either gas- or electric-powered, takes the cold water that enters your home from your well or utility company and cooks it until it gets hot. It's akin to an electric tea kettle.


Obviously, if your water heater is leaking, it will never fill with water so it won't have anything to warm. To see if this is the case, simply examine the area around the water heater to see if it is wet. If so, you'll likely need to replace the unit, but you can also call in a pro for a second opinion and to see if it is fixable. Sometimes leaks can happen around fixtures on the water heater, and if so, the solution might be as simple as replacing them.

 

Gas Heater: Gas Leak

 

If your hot water is fueled by natural gas and there is a leak in the supply line or where the line enters the tank, the appliance won't have the power it needs to heat up your water. The result is not only inconvenient, but it can be extremely dangerous as well. If you smell gas when you investigate your water heater, call your gas utility company immediately and report it as an emergency. It might also be prudent to leave your home until a repair person from the company arrives. Your utility company will usually fix any kind of gas leak. However, in terms of getting your water heater working again, you'll need to relight the pilot and wait a while to see if it is functioning properly. You can call in a water heater specialist or plumber to help with this.

 

Gas Heater: Pilot Light Problems

 

There are two other issues with gas-powered water heaters that can lead to a loss of hot water. The first is a pilot light that's blown out. The pilot light is the source of a constant flame inside your water heater. When the heater determines the need to heat up the water it is holding, it will open a valve that will cause gas to flow over the pilot light and cause it to ignite. To see if your pilot light is functioning, there is usually a small window in the front of the water heater. If you can't see a flame, remove the access panel and see if that helps you locate it. If there is still no flame, you'll need to relight it in accordance with the manufacturer's instructions.


Your pilot light should burn with a bright blue flame. If not, make sure there are no drafts affecting it, which could keep it from functioning properly. If the flame looks yellow, it might be a sign of the presence of carbon monoxide, which spells trouble and needs to be looked at right away by a technician.

 

Gas Heater: Faulty Thermocouple

 

The second reason why a gas-powered water heater might fail is a faulty thermocouple. This is a small probe that should sit in the pilot light flame. Its purpose is to stop the flow of gas if it senses that the pilot light is out. Sometimes, these probes get knocked off track, so make sure it is directly in the flame. They can also get a buildup on them that prevents their function, so try cleaning yours off with some steel wool or fine-grit sandpaper. If your pilot light won't stay lit and you've tried these steps to fix the thermocouple, it is likely faulty and needs to be replaced. Call a technician.

 

Electric Heater: Breaker Blues

 

Electric water heaters don't have pilot lights, because there is no gas to burn in order to heat up the water. Instead, they do their magic through the use of (naturally) electricity. But that's not to say things can't go wrong with them. If your electric water heater isn't working properly, there's a good chance that a breaker was tripped that supplies the appliance power. Check your breaker box and flip any breakers that have switched to the off position back on. If it trips again, then there might be a fault in the water heater, and you'll want to call in a pro to have a look.

 

Electric Heater: Reaching The Limit

 

If the breaker is fine, check to see if the high-temperature limit has switched off on the water heater itself. To do so, first turn off the breaker to the unit. Then remove the service panel and press the red button you'll find there. This is the limit switch, and resetting it could solve your problem. To check, replace the panel, turn the breaker back on and listen to see if the water heater is functioning again.

 

Electric Heater: Heating Element

 

If these steps don't fix the issue, then you might have a failed heating element, which will need to be replaced. Unless you are comfortable with such repairs, calling in a technician might make the most sense.

https://www.homeserve.com/en-us/blog/home-improvement/no-water-heater/


Hot Water Heater Repair

 

We were shown that editorial about What Would Cause My Electric Water Heater to Stop Working? through someone on a different domain. Sharing is nice. Helping others is fun. Thank you so much for going through it.




Request Appointment
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Reasons Your Water Heater Isn't Working”

Leave a Reply

Gravatar